Ask Experts Questions for FREE Help !
Ask
    eric2060's Avatar
    eric2060 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 14, 2013, 05:24 AM
    Furnace cycles once every time it goes into heat mode
    Does anyone know why my Furnace would cycle one time every time there is a call for heat? It goes through it's sequence then turns off and does it again then works fine.. I did change the ignitor before this started.
    pready's Avatar
    pready Posts: 3,197, Reputation: 207
    Ultra Member
    		  
    #2

    Sep 14, 2013, 09:12 AM
    Could be the sensor is bad, as I had a similar problem and once it was replaced my furnace works fine.
    dewey066's Avatar
    dewey066 Posts: 49, Reputation: 1
    Junior Member
    		  
    #3

    Sep 15, 2013, 08:37 AM
    Could be sensor, could be dirt/lint/spider-webs, etc.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace Gives Heat but Cycles Frequently [ 16 Answers ]

OK, Labman and others proved very helpful in the past with my ignitor problem so now I have another question: How long should a proper furnace run between cycles? I have read about the flame sensors and "limit switches" but I'm not sure if this is related to either. My heater seems to go...

Central heat and air unit indoor blower not working in ac mode but works in heat mode [ 2 Answers ]

Coleman model eb15b blower inside house works in heat mode but not in ac mode. When you turn it on ac everything runs outside and you can hear it making sounds in house but just freezes up. Turn it on heat it everything works fine and warm air comes from vents. Tested the thermostat with red and...

Furnace cycles on & off but very little heat [ 0 Answers ]

The fan comes on, then it cycles down, I can hear the pilot light click, then the roar of the furnace as it starts to light, then a loud click & the whole thing starts over again

Gibson furnace cycles different all the time [ 15 Answers ]

Hi,I noticed my gibson furnace m#KG6RK 072C-12A S#KGA021204267 cycling an not starting. It locked out.got a flashing light said I had a bad ground.so I took it apart and found nuetral wire melted to flue and other wires melted to inducer.I clip out bad wires and reconnected and cleaned off flame...

Furnace heat cycles on/off [ 1 Answers ]

We have an old furnace,not quite sure how old.It is a Bryant Quietair.I noticed tonight the burners would light,stay lit for a few seconds(30-40secs.),then go out,and then relight a few seconds later.The fan is running throughout the whole process like it should.This goes on constantly.What is...

View more questions Search