Ask Experts Questions for FREE Help !
Ask
    freeradical2's Avatar
    freeradical2 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Aug 16, 2013, 12:28 PM
    Control Flotec1/2 hp motor speed
    How can I vary the speed of my Flotec FP5512 well pump motor?
    Can I use a Titan controls mercury 2 fan speed controller?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Aug 16, 2013, 08:59 PM
    Why would you want to regulate speed? What is HP and Amp rating of switch?
    freeradical2's Avatar
    freeradical2 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Aug 16, 2013, 09:34 PM
    Half horse 6 amp I want to use it in my aqauponics setup and want to restrict the flow if I need to.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Method of speed control of ceiling fan motor [ 0 Answers ]

How can I control the speed of a single phase induction motor of a ceiling fan by controlling voltage?I need to design the circuit such a way that it would be possible to select three speed level, I need to divide the speed level into 2800, 2100 & 1400 rpm.

Does a variable speed motor on a furnace have the relay on the control board? [ 4 Answers ]

If so, can I buy the relay separately or is it part of the control board?

Wiring help, 2 speed condenser motor to 1 speed motor... [ 0 Answers ]

Ok, I am replacing my condenser fan motor on a tempstar smart comfort 2000, the old motor(2speed) has 5 wires, red, black, brown, blue, and green the new motor(1speed) also has 5 wires, white, black, brown, brown/white, and green.the schematics I can find for the motors, show white-red,...

I have a Jandy 2 speed motor to replace a 1 speed motor - help with wiring [ 5 Answers ]

Hi, I have a Jandy 2 speed motor to replace a 1 speed motor and need help with wiring. Before removing the old motor, I wrote down the colors of the wires to the old motor terminals (L2 blue, l1 black). Both went to a timer (black on position 2 of timer, blue on position4 of timer). The new...

20 Hp 3Ph motor, would like to control the RPM speed. Is there a way to do this? [ 1 Answers ]

It is wired 480v. Right now aand is connected to a dust collection fan (direct drive). I need to slow it down so I can control the cfm and static pressure inside the lines.

View more questions Search