Ask Experts Questions for FREE Help !
Ask
    gregroehr's Avatar
    gregroehr Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 13, 2013, 08:51 AM
    How to reset the burner control on a honeywell
    I have a whirlpool water heater with a honeywell burner control valve. I hear that there is a reset button on the honewell, which is not labeled, but will get the thing working again (It was turned off for a month, and now will not relight)
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Jul 14, 2013, 02:10 AM
    I am not sure about that valve, but they are all simple. Try turning it off and back to pilot and pressing the pilot button in until you clear out the air. It should light then.
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #3

    Jul 14, 2013, 02:45 AM
    What exactly is the heater doing? Pilot won't light? If so whirlpool heaters have a reset button on a sensor to the right of the gas valve, the little white button between the two wires needs pushed in then relight according to directions. (You will need to remove the front cover to see the sensor.) Good luck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to reset honeywell thermostat? [ 1 Answers ]

Honeywell thermostat keeps blinking and units is not on.

Filter reset on honeywell thermostat [ 1 Answers ]

Hello, and thank you for your help! I've found the answer on the Internet before, but foolishly, I failed to record the steps on the thermostat, so here goes. How do you reset the filter on a Honeywell Chronotherm IV electronic thermostat? Thank you in advance to your response to my...

How to reset Honeywell thermostat , RTH 22 [ 0 Answers ]

Bryant furnace - must press manual rollout reset for burner to ignite [ 2 Answers ]

My Bryant 350MAV furnace is not working properly. While the blower is first running it flashes a code 12. Then the light goes on solid and the burner never ignites. If I hold the manual rollout reset button for 20 seconds the ignitor starts to glow and the burner ignites. What needs to be...

Oil primary control reset will not reset. [ 2 Answers ]

Oil primary control green light flashing. Will not reset due to loss of prime. Just Finished cleaning. Changed filter and obviously Has to be bled. AFG model Becket burner 2 years old. How do I get the reset to reset so I can bleed the system? All working till now. Bruce

View more questions Search