Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Electric furnace humming even when not running
[ 5 Answers ]
Hi everyone. I have a question about an electric heater I just got. It is a Dayton model TYV14, 240 volt, 38 amp, 9.2kwh. It seems to be working OK, thermostat is OK, but the question I have is should it make a humming sound, even when not in a heating/blowing cycle? There is a very quiet hum...
Small current running through showers.
[ 6 Answers ]
Ok I have just opened a gym in Dublin Ireland but there is a small current running through the showers, about .1-.5 of a volt. I think it is a backlash of the neutral because even when I turn off the mains from the circuit box it still happens. I don't have any reset button on the board. I am open...
Bath tub shower spout & head running water running at same time
[ 1 Answers ]
I started with a slight dripping problem(sayko system).i decided to replace all 3 stem assemblies together as they all were about 18 years old.after reassembling the new stems(danko brand),turned on the water supply & checked faucets.hot & cold worked fine but when the shower was turned on,water...
Running Electric, Cat5, and Telephone Cables
[ 1 Answers ]
Hi -- I'm new to this site! Thanks for making it available. I have a new 18x36' shed that I am going to put a sub-panel in. The sub-panel will be 100 amps and is approximately 120' from the main panel located in the main house. So, I will be running underground electric cable from the main...
Amperage lost from a current transformer to utility's electric meter(?)
[ 2 Answers ]
I work for an Electric utility. Have noticed that the actual amperage running through a phase does not match the amperage being sent to the meter with it's proper multiplier from the current transformer (CT)? Example: phase A is using 83 amps. The X1 tap to the meter from the current... View more questions Search
|