 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
A "standard" well tank, also known sometimes as a pressure tank is just a tank and is usually galvanized to prevent rust. It is just a sealed tank with fittings for pipes.
A bladder tank is a tank with bladder inside, usually made of some kind of rubber. The bladder is like a balloon inside the tank. These are usually painted on the outside to prevent rust. The inside is usually treated to prevent rust. The bladder tank will have a valve stem (just like a car tire) to inflate the bladder. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I want to use a holding tank to supply fresh water for a flush and outside shower at my cottage in a bunk house. Is there a demand pump I can use instead of having a holding tank with a pressure switch? If so what is the pump called?
I have a well that that was constantly being triggered each time the water was turned on or a toilet flushed. The gauge would constantly tick as this happpened. Because I needed a water filter for iron removal I was advised that I should have a pressure tank because the well pump could eventually...
Tried browsing for an answer to my question and while there was relevant info, it didn't directly answer it, so here goes... My house and my direct neighbor's house are fed by a shared pump from a well about 400 meters below our houses. Each of us have a header tank, our sits in their garage...
When I turn the pump on to our camp well, I hear a gurgling sound from our pressurized water storage tank. Everything seems to work fine and cycling is good but the gurgling sound is getting worse. It only occurs the first time I turn the well pump on. The pump is turned off when we leave and we...
Getting old I guess, anyone know the tank to bowl bolt spread on a American Standard Plebe (the old ones), can't remember if 51/4 or 51/2 inches.
View more questions Search
|
