 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Whirlpool washer won't do anything after filling with water.
I have a full load in my washer & it won't do anything. I hear a buzz for a few seconds, a click, then nothing. I moved it to the spin cycle to drain water & again it buzzes, clicks, then nothing. Please help!
|
||||
|
||||
|
There are two possibilities: The water level switch and the timer. Check the water level switch by disconnecting the hose (get water out first) going to the switch. Leave the hose attached at switch end and blow on it as you have an ohm meter attached to the common and normally open terminal. The switch should close when you blow on the hose and open when you release the pressure. If it does not do so then you have found the problem. Power leaves this switch and goes to the timer. Here are some manuals: https://dl.dropboxusercontent.com/u/...%20Washers.zip
https://dl.dropboxusercontent.com/u/...c%20washer.pdf https://dl.dropboxusercontent.com/u/...e%20Manual.pdf |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
We have a whilpool washer model LXR7244JQO and it won't empty the water. This washer hasn't been used for about 8 months.
Washing machine: Kenmore 70 Series washer. (sry, don't know model number, that plate is missing) Issue: During load of laundry, hot water continued filling during the entire cycle. Wash, rinse, spin, and even after the washer reached the 'Off' position. All other functions of the washer...
Our whirlpool washer has been slow to fill with cold water. Very little cold water pressure. Tap is full open.
I have been filling my washer with a hose from my downstairs sink. When it gets to the rinse cycle I have to fill it AGAIN:mad: I called sears and told them what was wrong but they sent me the wrong part:mad: I was sent the pump that pumps the water out! Please help!:confused:
View more questions Search
|
