 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Gas valve solenoid 36c03 type 333
My solenoid burned out. I have a resistance of .8 Meg. I have 28 volts AC to the solenoid. The pilot light lights and stays lit with a blue flame, but when the thermostat is turned up and voltage is applied, I get no flame, no click, nothing. My question is does the valve come apart so I can access the solenoid or do I need a whole new unit?
|
||||
Check out some similar questions!
I have a 36C03 gas valve on a Rheem gas furnace. I just need to know where the wires from the high limit go? They broke off and I don't know which is which.
I have a Rheem furnace and a Model 36c03 gas valve. You hear the clicks when you put the furnace on and it lights but when you turn it off the gas does not shut off. Do I need to replace my gas valve?
My pilot in my furnace lights and starys lite for a number of days. Then the pilot goes out, usually in the middle of the night. I have changed the thermocouple but still getting the same results. The pilot looks OK. Blue flame about 1 inch long with a slight yellow in the tip. Any...
I need to install a White-Rodgers Universal Standing Gas Valve model 36C03 on a Colemand mobile home furnace model 7670A. The old control which was made by General Controls is absolete and had three small gas lines labeled vent, pilot, and one on top that was not labeled. I can figure out the vent...
Valve was installed 2 or 3 years back and has worked find. I can light the gas pilot light and it has stayed light for days. I has a little yellow in the flame. When the heater is turned on via the thermostat, the valve supplies gas to the main burner, it ignites and the pilot light is either blown...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
