Ask Experts Questions for FREE Help !
Ask
    papadavisgolf's Avatar
    papadavisgolf Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 13, 2013, 12:02 AM
    Is there further cutting height adjustment other than the lever on a Craftsm rider ?
    My Craftsman riding mower has the 6-position cutting height adjustment lever. Is there any way to further adjust the cutting height? It seems the low position is too low.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    May 16, 2013, 02:08 PM
    Hi,
    You can adjust the linkage beneath the frame to get a higher cut. Most of their manuals cover as deck leveling but need the model number here,
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honda 3013 rider - Engines stalls when try to engage PTO lever [ 3 Answers ]

Hi, Just purchased used Honda 3013 rear engine rider. Right off bat replaced the neutral safety switch under seat as engine would stall when moving transmission either forward or reverse (would idle in neutral ok). Now that I can go forward or in reverse, when I try to engage the PTO lever the...

Belt adjustment for Murray 42 in 17.5 hp rider mower [ 3 Answers ]

Can you tell me where the adjustment is for tightening the blade drive belt on a Murray 42" 17.5 hp rider mower?

Mower Deck Height Adjustment [ 6 Answers ]

Own a TroyBuilt LTX 2146. Need to know how to access the mechanism that controls the mower deck height adjustment. Although the deck is set on the highest notch, it is scalping the grass. Can tell it has dropped because the custom made blocks, used to ensure the deck is level after maintenance,...

View more questions Search