Ask Experts Questions for FREE Help !
Ask
    romerobengal's Avatar
    romerobengal Posts: 1, Reputation: 1
    New Member
     
    #1

    May 15, 2013, 11:41 AM
    Pilot light won't stay lit on water heaters. I already replaced the thermocouple
    Pilot light won't stay lit on water heaters. I already replaced the thermocouple
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
     
    #2

    May 16, 2013, 06:47 AM
    You probably have a bad gas valve or the flame is not hitting just the 3/8" part of tip of thermocouple. If it's not adjusted right it will not work. The only way to know if the gas valve is bad is with a meter. Set meter to ohms at the kilo-ohms scale. Then unscrew the thermocouple and measure from the contact in the center of the bottom of the hole to the side (ground) of the gas valve. If you read several k-ohms then it should be good; if it reads infinity (open) then it's bad. You also have a gas volume adjustment that will increase or reduce the size of the flame on the pilot light. It's usually a small screw on the side near where the gas tube connects to the gas valve. Try these instructions and it will be fixed in no time.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace will light but won't stay lit. New thermocouple installed last winter [ 1 Answers ]

Should my thermostat be set to a specific temperature?

Forced air furnace who's pilot won't stay lit, not the thermocouple [ 1 Answers ]

Pilot won't stay lit beyond releasing the button to light it. Replaced the thermocouple--same result. 45 year old Pioneer heater. Tested for power at the transformer--OK. What next?

Gas water heater pilot light won't stay lit [ 2 Answers ]

The pilot light on our State Censible gas water heater will not stay lit... it is not the thermacouple and it is protected from drafts. We light it daily... we get enough hot water for about 2 showers and a load of dishes. What could be causing this problem?


View more questions Search