 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
89 K5 No power to injectors
I have an 89 K5 5.7 tbi. I was backing out of driveway and it died. I have replaced the ECM, ICM, and coil. That is when I replaced the parts. Getting power to injectors but when noid light gets hooked up no pulse light. I have checked every inline fuse I could find and checked the 2 fuses under the dash.
|
||||
Check out some similar questions!
Hi I have a 1990 k5 blazer with a 92 350 in it. I was going into town and it just stalled would not start unless I sprayed starting fuild into the TB. So I checked online and someone said to check to see if there was power to the injectors so I did and there is no power how do I find where the...
Hi everyone---Just finished installing re-built injectors following normal procedure. I managed to start engine. It was a bit bumpy so I revved it a little. After two minutes or so it just shut down and won't start. I noticed some fuel dripping from under the engine and so checked that the filter...
My question is I have a 04 f-250 6.0 with two bad injectors. The dealer says that all eight should be replaced at the same time. At a cost of about 2400 just for parts. Is their any reason to replace them all instead of just the bad ones?
My 5-speed 92 civic has to have the gas peddle down with the clutch to start. Could it also be my fuel injectors that is dirty?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
