Ask Experts Questions for FREE Help !
Ask
    1990 k5 blazer's Avatar
    1990 k5 blazer Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 21, 2012, 02:55 PM
    1990 k5 blazer no power to my injectors
    Hi I have a 1990 k5 blazer with a 92 350 in it. I was going into town and it just stalled would not start unless I sprayed starting fuild into the TB. So I checked online and someone said to check to see if there was power to the injectors so I did and there is no power how do I find where the problem is. Any help would be great thanks
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Jul 21, 2012, 05:07 PM
    Frequently, vehicles will only run with starting fluid, if the Ignition Control Module (ICM) is bad.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have no spray out of the injectors on 1990 chevy truck 350 throttle body [ 13 Answers ]

I drove the truck in the garage and removed the engine. I had two bent valves. I removed the engine, had it rebuilt, and put it back in the truck. I tried to start it and no spray from the injectors. I can pour fuel in the throttle body and it runs. I have checked and replace the ignition module,...

Have a 1990 chevy p/u, m having injector problem, is the ground for injectors fed thr [ 0 Answers ]

I am having injector problems on 1990 chevy p/u. have fuel to and fire to injectors but fuel does not inject into throttle body, I noticed that the check engine light quit working at same time this problem started. Computer removed and tested working fine. Truck will start and run when manual...

7.3 power stroke won't start after changing injectors [ 0 Answers ]

Hi everyone---Just finished installing re-built injectors following normal procedure. I managed to start engine. It was a bit bumpy so I revved it a little. After two minutes or so it just shut down and won't start. I noticed some fuel dripping from under the engine and so checked that the filter...

1990 1500 Blazer Gas Tank Sending Unit [ 2 Answers ]

1990 1500 Blazer... Gas gauge reads well above full and drops to 1/4 or 1/2 tank reading quickly... was told (bought used) that it is empty on 1/4 tank. How do I trouble shoot sending unit? Also, oil pressure gauge pegs when started but not when key on no matter if hooked to sending unit or not?

View more questions Search