 |
|
|
 |
New Member
|
|
Apr 2, 2013, 11:22 AM
|
|
How to handle sudden drop in sewer line
I want to build a bathroom in my garage on top of the cement slab. I can elevate the toilet so no problem there. However, where the sewer line exits the garage, I have only a one foot space in a planter area to get under a walkway. This means a sudden drop of 5 inches in a one foot space. Would two 90 degree bends be better than two 45's to make that 5 inch drop? I am thinking that, this would be the best way to keep the water from washing away from the solid waste.
|
|
 |
Uber Member
|
|
Apr 2, 2013, 02:46 PM
|
|
I would go with 45's. They will allow easier flow than 90's. If you need to use 90's make sure to use a long sweep elbow.
|
|
 |
Plumbing Expert
|
|
Apr 2, 2013, 03:02 PM
|
|
As suggested in above post, I would also use 2 - 45 degree bends to negotiate the drop. That assures better flow. If you are short on space, try to use Street 45s to save couple of inches. If no slack to make the final connection, use Fernco Flex Seal coupling.
Back to you / Milo
|
|
 |
New Member
|
|
Apr 3, 2013, 10:48 AM
|
|
Okay. Thanks for the tips. After having thought about it some more, I realized I was going to have to put in a sanitary T so that I could also go straight up for my main sewer stack. Of course that in turn means the sewage will drop straight down. So I guess that calls for a single long sweep 90 elbow. Does that sound about right?
|
|
 |
Uber Member
|
|
Apr 3, 2013, 11:08 AM
|
|
Why not a sanitary Y and a 45 degree sweep.
|
|
 |
New Member
|
|
Apr 3, 2013, 11:50 AM
|
|
 Originally Posted by ma0641
Why not a sanitary Y and a 45 degree sweep.
Sounds good but, would that require another 45 for the sewer stack going up as well?
|
|
 |
Uber Member
|
|
Apr 3, 2013, 11:55 AM
|
|
I guess I thought you were going from a horizontal line into the stack.
|
|
 |
Eternal Plumber
|
|
Apr 3, 2013, 09:08 PM
|
|
If this is going to be a toilet, lavatory and shower I can see you platforming most of the garage. Why not break up the slab and end up with a professional looking job. You have the pitch and fall tom make it work. Here's a typical bath layout. Good luck, Tom
|
|
 |
New Member
|
|
Apr 4, 2013, 11:56 AM
|
|
 Originally Posted by ma0641
I guess I thought you were going from a horizontal line into the stack.
Yes. I guess I just thought I needed another 45 to go straight up with my stack which would be 90 degrees to the line coming out of the wall.
|
|
 |
New Member
|
|
Apr 4, 2013, 12:07 PM
|
|
 Originally Posted by speedball1
If this is gonna be a toilet, lavatory and shower I can see you platforming most of the garage. Why not break up the slab and end up with a professional looking job. You have the pitch and fall tom make it work. Here's a typical bath layout. Good luck, Tom
Thanks Tom. That drawing is basically what I had planned except my shower and vanity lines will be hidden by the vanity cabinet and broom closet. Since the toilet will be elevated, those lines will be hidden as well. Didn't want to break up the concrete if that could be avoided. Here's the kicker. I plan to squeeze all this in below the garage door as it opens. I measured the height of the garage door and I have 81 inches when it lifts in an opened state (have to make a pocket for the armature swing), so I calculated this could be done if I make my bathroom ceiling height only 6' 8" instead of 8 feet. A custom job to be sure, but I think doable.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Sudden Voltage drop
[ 1 Answers ]
For last few days I notice that around early morning (it's winter now) my home power line voltage drops for a second or two (few times randomly) Surprisingly for the rest of the day it is working fine. Any suggestion
Sudden drop in cold water pressure
[ 0 Answers ]
Hi all
I have a house that is 3 separate apartments. Within the past week 2 of my apartments have a problem with the cold water in the shower. What I have been told is that while taking a shower the water will randomly get scalding hot. To me it seamed like the classic toilet flush. But they are...
Sewer line drop and bends
[ 8 Answers ]
I have a sewer line that runs about 75 feet then I have a 45 degree bend to the rest of the line which is about another 75 feet. 2 questions: first, there is plenty of drop as it is downhill all the way, but can it drop too fast? If so what is the maximum drop I would want? Second, is the 45 degree...
Sudden pressure drop whole house
[ 1 Answers ]
Hi there:
My sister in law has had a sudden water pressure drop in her entire house and the water dept has come out and said her pressure to the house is fine. The water in her faucets comes out normal at first but in seconds is reduced to virtually a trickle. She has two water heaters and her...
Sudden voltage drop in an electrical line?
[ 3 Answers ]
I removed a fluorescent light and replaced it with a ceiling fan/light combo a little over a month ago. It was working fine until two days ago. I turned the switch, the lights flickered and then the whole thing went dead.
When I use a circuit tester the test light is lit, but it looks dim...
View more questions
Search
|