[tim2515]

I bought a manufactured home with two bathrooms. Both bathrooms have Mansfield 160s. The main bathroom has its original Hardware and flushes fine. In the master bathroom the hardware in the tank has been replaced with fluid master flush valve and fill valve. When you flush the tank empty completely the bowl fills up to the rim and then goes down slowly. If I put a plunger in the bottom of the bowl to block the toilet, flush the toilet till the bowl fills and remove the plunger the bowl will empty with a WOOSH. What could be causing the problem?

[Milo Dolezal]

Bowl filling up to the rim after flush indicates there is an obstruction inside the bowl itself. You can do one of the two things:

1. Take a plunger and plunge the toilet
2. Take 5' auger snake and snake the bowl

That should help

Back to you / Milo

[tim2515]

Bowl filling up to the rim after flush indicates there is an obstruction inside the bowl itself. You can do one of the two things:

1. Take a plunger and plunge the toilet
2. Take 5' auger snake and snake the bowl

That should help

Back to you / Milo

Thanks Milo. After doing more research, it turns out it was the siphon jet that was clogged. Deliberately clogged with wood putty. After removing the clog the toilet flushes beautifully. Thanks again for your advice