Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Aqua Air Model V60 pressure tank, water is coming out of safety valve
[ 14 Answers ]
I have a Aqua Air Model V60 pressure tank. When water is used, the pump runs and after it stops, water comes out of the safety valve (about half a cup). The pressure gauge above the safety valve shows 62 psi. Tank is showing 44 psi. Do I need to replace the safety valve?
Directions to run pipe from cold water tank & pressure valve
[ 0 Answers ]
When geothermo unit starts one water tank stays full & my second tank ever fills & I think my plumber has the pressure switch & the pressure gauge in the wrong places.
I have incoming water psi at 88---no pressure reducing valve, do have expansion tank
[ 10 Answers ]
Hot water tank failed at 5 years---on a 12 year warranty. Had new tank installed----
Hot water tank leaking at pressure valve tube
[ 3 Answers ]
Our gas hot water tank 4 years old started leaking slowly at the TRP valve pipe however I noticed when water was running else where in the house (EX: dishwasher flush toilet shower) it doesn't leak. I have the laundry sink cold water turned on to a trickle and the hot water tank doesn't leak...
Replaced a hot water tank,water is not going to the pressure tank-the pump stays on
[ 2 Answers ]
Replaced a hot water tank, turned the pump on and the water is bypassing the pressure tank. The pressure tank will not fill up and the pump remains on and will not shut off. We do get water though but needs to shut off the pump so it will not burn out. Any thoughts? Thank you Any ideas will... View more questions Search
|