Ask Experts Questions for FREE Help !
Ask
    Rob2770's Avatar
    Rob2770 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 16, 2013, 11:38 AM
    Is there a way to obtain constant power to a GFCI that was jumped of a light fixture.
    My switch controls the light and GFCI, the power goes to the light 1st then it's jumped to the GFCI would there be a simple solution to get power constantly to the GFCI.
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
    		  
    #2

    Mar 16, 2013, 12:01 PM
    Where does power come into area? At the light or the switch?

    If power comes into light it is not hard to set GFI with dirct power.

    If power comes into switch it will take a lot of work.

    Chuck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Why no power to light fixture when other lights on same circuit are fine? [ 3 Answers ]

While attempting to install a replacement light fixture, the fuse blew so I attempted to improve the electrical connections to the light fixture and then I reset the fuse. I then heard a fairly loud buzzing noise and within about 3 seconds, I manually flipped the appropriate fuse breaker to the off...

Changing light fixture no power now? [ 1 Answers ]

I hooked up the light and it worked great but now I have no power to the two bedrooms that are on the same circuit what to do?

Light fixture shorted out, replaced fixture, now no power [ 4 Answers ]

In my bathroom, I have 1 grounded receptacle, & (1) 2 wire light switch that controls the 4 bulb light fixture. This is on a circuit with my upstairs lights & outlets, which all work with no problem. The bathroom receptacle has never worked, I replaced it after moving in house 10 years ago, & it...

Outdoor wiring of switched plug and constant power to motion light [ 1 Answers ]

I need a wiring diagram to control a switched receptacle and a motion light. The power to the motion light must be constant. The power to the receptacle switched. Any help would be appreciated.

How to restore power to a light fixture and outlet [ 1 Answers ]

I have a ceiling light in my girls playroom that just stopped working we tried to put in a new light bulb did not work so I bought a whole new fixture installed still did not work also the next day went to urn on their TV and it also would not work but there are two other outlets in the room that...

View more questions Search