Ask Experts Questions for FREE Help !
Ask
    majorbob4's Avatar
    majorbob4 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 13, 2013, 09:18 AM
    Fluorescent Fixture Problem
    We have a fluorescent 2 tube fixture in our closet. I noticed a tube out so I replaced it. The tube flickered a bit but would not light, the other tube is lit. I turned the switch off to make sure the tube was seated properly, which I believe it is. The tube will still not light. However, when I tap the end of the fixture body the tube will light up. Turning the wall switch off and then on the tube will not light. I'm puzzled and don't know what to do. Any help you can give me will be very much appreciated.

    Regards,
    Bob
    hfcarson's Avatar
    hfcarson Posts: 1,003, Reputation: 49
    Ultra Member
    		  
    #2

    Mar 13, 2013, 11:51 AM
    Try (2) new lamps...
    Handyman2007's Avatar
    Handyman2007 Posts: 988, Reputation: 73
    Senior Member
    		  
    #3

    Mar 13, 2013, 04:39 PM
    Yes. That would be the ting to do. Sometimes the ballasts can be temperamental and need 2 new bulbs to fire properly.
    Kyle_in_rure's Avatar
    Kyle_in_rure Posts: 341, Reputation: 10
    Full Member
    		  
    #4

    Mar 13, 2013, 05:07 PM
    Two new of the same brand and type.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Fluorescent light fixture not working [ 2 Answers ]

Only one of the bulbs will light. I got a continuity checker out and found one part of the ballast which does not have continuity. I don't know where I would get a replacement part and don't even know what kind of part it is. I'm guessing since there are two of the same items and one does not...

Fixture problem [ 1 Answers ]

I have this same fixture, but mine does not seem to work. It's seems to be stuck. Any suggestions on how to maybe loosen it so that is turns to remove?

Fluorescent tube Fixture Problem [ 1 Answers ]

I have the following situation and I want your opinion and advice: ==> 1 light switch controlling 1 light fixture with 1 magnetic ballast(120 Vac) and 2 X F96T12/60 W fluorescent tubes. Problem: Both fluorescent tubes initially light when the light switch is turned on however, after a...

Removing Fluorescent for New Track Lighting Fixture [ 1 Answers ]

After cutting power and removing the fluorescent light fixture I noticed the old fluorescent unit was wired directly to the main wire, bypassing the box previously installed in the ceiling. No ground had been connected either. Now I want to install the new track lighting fixture, but want to...

Replacing Ceiling Fixture Problem [ 1 Answers ]

We are trying to replace two single light pendants with two double lighted ceiling fixtures. In the room there are three single pendant lights that are controlled with a single light switch. The problem we are having is that the new ceiling light fixtures have two sets of black/white/ground...

View more questions Search