Furnace fan cycles on and off

xdyang Posts: 1, Reputation: 1

New Member

Feb 20, 2013, 10:34 PM

Furnace fan cycles on and off

I have fan problem with my Trane furnace. When I set the temperature to 72, and turn it on to heat up the house, it works for about 5 min (reading temperature is 65) and then the fan shut off, but the fire stays on.
I put the heat/cool to "off" and the fan to "on" (not auto), just turn on the fan. The fan turns on but shut off after 20 to 30 sec. About 30sec later, it turns on again. But it shut off again in about 20 sec. Then it cycles likes this way.

Check out some similar questions!

Carrier furnace purge fan cycles on and off when not needed [ 0 Answers ]

I have a carrier forced air furnace. The exhaust fan keeps turning on and shutting off at random. It usually only does it when its warm enough outside that the furnace won't kick on I have the thermostat set at 65 degrees and is 72 in the house there's no need for the heat to turn on but the...

Furnace fan cycles off and on every 90 secs. [ 0 Answers ]

1984 coleman 7680c856 standing pilot light. Burner runs reaching operating temp blower fan kicks on for 90 secs then cycles off for 2 1/2 minutes. Then back on for 90 secs while burner runs the entire time.replaced with new gas valve,fan switch,limit switch.flame on burner appears blue. Acts...

My Goodman GMP050 furnace's igniter won't shut off after the furnace cycles. Why? [ 0 Answers ]

On my 15 yr old Goodman GMP050, the preigniter stays hot orange even after the furnace cycles properly. I've sanded the flame sensor and the igniter but it still stays on till I shut off the electricity at the furnace. Any thoughts? It's COOOOOOLLLLLLDDDDDDDDD!

My blower fan/furnace motor on my natural gas/air conditioning system short cycles? [ 1 Answers ]

This summer I had my air conditioning unit replaced after the previous one unknowingly froze up and as a result blew up. The new unit was working well after it was installed in conjunction with the natural gas furnace without issue - albeit the blower on the furnace unit distributes the cold air...

Bryant furnace fan cycles on 1 or 2 times for 2 or 3 sec. After heat cycle has ended [ 8 Answers ]

I have a Bryant furnace Mod. #394GAD024050 and after the temp has reached the set point and the furnace has cycled off the fan will come back on a couple of times for approx. 2 or 3 seconds. In the older furnaces with a machanical fan/limit switch some times the temp would creep up and cause the...

View more questions Search

Check out some similar questions!

Add your answer here.