 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
My Goodman GMP050 furnace's igniter won't shut off after the furnace cycles. Why?
On my 15 yr old Goodman GMP050, the preigniter stays hot orange even after the furnace cycles properly. I've sanded the flame sensor and the igniter but it still stays on till I shut off the electricity at the furnace. Any thoughts? It's COOOOOOLLLLLLDDDDDDDDD!
|
||||
Check out some similar questions!
Goodman furnace appears to only have a heat sensor and a flame sensor, I sanded the flame sensor,it had some dark spots on it and I examined the heat sensor but it appears normal it does have a clicking noise in it when shooked back and forth? System runs OK but flames are cycling on and off so not...
Hi,hope you can help me out.i have a goodman manufacturing forced air furnace that i believe is giving me a warning sign of a future failure.what has happened is in this order,1st one morning the thermostat showed that the furnace was on and it was'nt.turned it off and then back on at the...
I have a Goodman furnace about 9 years old. The house is also 9 years old. It has been working okay for the last 2 years. Last week it started giving longer intervals between heating cycles i.e. it comes on for 20 minutes after every one hour. The service tech replaced the flame sensor and declared...
It is goodman gmp050-3. the red light blinks 3 times. I have replaced the pressure control switch and the thermostat. But still no change. Could I have gotten a bad pressure control switch. What else could it be? HELP
I have a Goodman 70,000 BTU, up flow gas furnace (GMV950704CXA) with a Honeywell (RTH 7500D) thermostat installed, November 2006. The unit worked fine until outside temperature went into the 20s. Unit fires and goes through normal sequence and runs for approximately 7 minutes, then cycles down...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
