Ask Experts Questions for FREE Help !
Ask
    Don L's Avatar
    Don L Posts: 2, Reputation: 1
    New Member
     
    #1

    Feb 6, 2013, 07:15 AM
    Idle problems
    Have a Agway Snow blower model 523.Plug from Carb fell out.Replaced and now the engine idle goes up and down.The carb was replaced last year has only a few hours running time.5 hp Tecumseh motor. Ran good until that plug fell out.Carburetor P/N 640084B
    odinn7's Avatar
    odinn7 Posts: 7,691, Reputation: 1547
    Entomology Expert
     
    #2

    Feb 6, 2013, 08:06 AM
    I have no idea what plug you mean but I would say that there was either a spring or gasket that you didn't put back with this plug or that it needs to be adjusted.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #3

    Feb 6, 2013, 05:53 PM
    Hi,
    I gather you mean the welch plug that govers the low speed circuits, so the cure is to seal the edges of the replaced plug with fingernail polish to seal it and prevent air slipping past it.
    Peace,
    Clarke
    scott53715's Avatar
    scott53715 Posts: 165, Reputation: 10
    Junior Member
     
    #4

    Feb 7, 2013, 01:02 AM
    The float bowl has a needle style plug with a spring and small washer. You need all three and can be found at most lawn and garden centers that sell and repair garden equipment. Adjusting this screw plug will affect the running of your engine. Start with tightened up firmly and the releasing about 1 to 2 turns.
    Don L's Avatar
    Don L Posts: 2, Reputation: 1
    New Member
     
    #5

    Feb 7, 2013, 06:49 AM
    Quote Originally Posted by crigby View Post
    Hi,
    I gather you mean the welch plug that govers the low speed circuits, so the cure is to seal the edges of the replaced plug with fingernail polish to seal it and prevent air slipping past it.
    Peace,
    Clarke
    Sounds like a plan. With all this snow coming.. Will try it.. By the way thanks for your help.. Don L

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Idle problems [ 0 Answers ]

Got my honda civic 97 LXi, I have a check engine light on, and unstable RPM on idle, it jumps back and forth on 1400-1600 rpm, I tried to unplug the IACV but still the same, though in running the car even on a highway there are no problems, just when the car is on idle, do I need to replace my...

2000 Honda Civic VP (DX) idle problems [ 7 Answers ]

Hi, I noticed many helpful posts and would like to ask for some advice on my wife's 2000 Honda Civic VP 1.6l. It has almost 80k miles on it. Recently, the car had been idling pretty rough, to the point that it would vibrate and stall at a stop sign or traffic light. Then the "check engine"...

88 civic idle problems [ 1 Answers ]

When the car is cold it idles just fine.. But after its warmed up, the motor will rev up slow down, rev up, slow down. etc.. Like some one is just pressing and letting of the gas peddle. It doesn't rev a lot. Just a littlle back and forth. What's causeing this? Will also do this in gear when just...


View more questions Search