 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kenmore Dryer - Model 110.96281100
I have a Kenmore dryer - model 110.96281100 which stops mid-cycle or won't start at all. Removing the timing unit revealed a bit of black dirt which I cleaned. It worked fine for about 2-3 days but then went back to same old status - sometimes starting, sometimes not. I'm trying to figure out if I need to replace the timer or the resistor. Any help out there would be appreciated.
|
||||
|
||||
|
KENMORE WASHER AND DRYER
Epinions.com - Posts in Sears Kenmore Elite Dryer Won't Run If Start Button Released |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Where is the heating element located on a Kenmore Dryer, Model #110.86873100?:)
Please help: My Kenmore dryer has been shutting itself off after a few minutes; before completing its cycle, it will restart when pushing the start button. But will shut off again after a few more minutes.
My dryer stopped heating although it runs. I confirmed I was getting 240volts at the source. I checked the continuity of the element, the thermal fuse and the thermostat and found that they were continuous. I have read that the thermistor might have something to do with it...
The washing machine is not spinning, so I am attempting to replace the coupler. I am able to partially remove the front console, but I can not remove the main knob. I found instructions that say to hold the dial and turn timer knob counter clockwise, but this is not working. This should be...
View more questions Search
|
