Ask Experts Questions for FREE Help !
Ask
    lemonlime's Avatar
    lemonlime Posts: 44, Reputation: 1
    Junior Member
    		  
    #1

    Jan 29, 2013, 04:19 PM
    American Standard Oil Burner oil pump shot
    American Standard Oil furnace model ACD 603 pump stuck and won't turn. What is the equivalent for a Sundstrand 1298 100 3 that I have.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Jan 29, 2013, 06:50 PM
    I'm not familiar with that Sunstrand number but I presume it is a 'J' model with 8 bolts holding the strainer cover on. If this is the case, you could replace it with an A1VA-7112. You would also have to replace the coupling between the motor & the pump since the pump shaft is shorter & smaller.
    lemonlime's Avatar
    lemonlime Posts: 44, Reputation: 1
    Junior Member
    		  
    #3

    Feb 1, 2013, 09:13 AM
    Hey Grady thanks for the response, the pump is very old could be original where you able to get pump number by the unit model ?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #4

    Feb 1, 2013, 04:42 PM
    No, I was not but if it is the burner I think it is, the A1VA-7112 will work. A clear picture of the burner would certainly help.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Oil Burner still dripping.Oil Co. Tricks.fear for 3 dogs lives [ 8 Answers ]

That 1 you see as a response to my boiler question was to redirect my boiler question to heating and cooling. Please refer to boiler burner dripping below. Still need an answer as am not willing to have the tricky oil companies service my problem after causing it. They want to see more dollars...

Oil burner blows back oil [ 10 Answers ]

My oil burner repairman cannot figure out why the oil is blowing back into the part that is attached to the pump. Everything has been replaced, nozzle, pump, eye, etc. It is a Beckett burner and the nozzle that is in there is .75/80 hollow. Why would the oil blow back, 0other than the nozzle is...

Circulator pump works but oil burner does not fire [ 6 Answers ]

Hello, I have a 2 zone heating system, forced hot water with oil burner/boiler. Also heats domestic hot water tank/coil. Everything works fine EXCEPT zone 2, which is only the living room. When the thermostat is turned up, the circulator pump goes on but the oil burner will not. The...

Bryant oil furnace (#369AAN) with Beckett AFG oil burner [ 1 Answers ]

I was curious as to if anyone can tell me anything about the above product(s). Reason being is because I had no choice in which new high-efficiency furnace would be installed. I have a home warranty through AHS (which is horrible) and this is the product that was installed. Is Bryant as good as...

How to conceal the oil tank and the oil burner [ 6 Answers ]

Hello! We have a 375 gallon fuel oil tank in basement (its an old tank) and burner. We are looking to finish basement. What can be done as far as enclosing, partioning, concealing, etc. the fuel tank and the oil burner? We live in Massachusetts! Thanks!

View more questions Search