Ask Experts Questions for FREE Help !
Ask
    HANDY WANNABE's Avatar
    HANDY WANNABE Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 27, 2013, 07:19 AM
    State select electric water heater
    I have a State Select electric water heater (M/N ES630DOLSG) that was not heating water. Then I was told A/C on top wet the electrical component and tripped the circuit breaker. Now its all dried out and breaker stays on but no water when faucets are turned to hot water side... all faucets and dishwasher not having any water. How do I reset? So the water heater will fill with water to heat and distribute? Thank you thank you
    rdn's Avatar
    rdn Posts: 9, Reputation: 1
    New Member
    		  
    #2

    Jan 27, 2013, 07:51 AM
    Do you have cold water coming through the tap ? Check your ground fault recp.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #3

    Jan 27, 2013, 08:36 AM
    Are you saying that you have no water flowing out of the faucets or feeding the dishwasher? If that is the case then someone probably shut the cold water supply valve (see image) that feeds the water heater. Open the cold water supply valve on the cold water pipe and that should restore the water flow. You'll need to clear the hot water pipes of air by opening the hot side of the valves/faucets for a minute or so to get good, clean water flow.

    Back to you...

    Mark
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

State Select Electric Hot Water Heater [ 11 Answers ]

I've had several plumbers check my lowboy heater and say it checks out okay, but it runs out of hot water in 20 (actual 18) minutes. It's a 50 gallon water heater. I've been told that 20 minutes is the minimum time and it is very low. I would like to be able to take a shower and then soak in...

Troubleshooting state select electric water heater? [ 1 Answers ]

My State Select Electric Water Heater Model # PR650XBPDTD; Serial #: F04423256... won't ignite. I replaced the Ignitor assembly and it continues to give me the same error code on the temp panel: far left green light and the A & B are yellow. Please Help!

State select electric water heater [ 1 Answers ]

Hey Speedball1, I have a State Select water heater that the reset button has to be pushed every morning. It is the red button on the water heater its self. Sounds like a common problem with this heater. What do think is causing it, and how do I test to be sure? And where do I get a...

State Select electric water heater [ 1 Answers ]

The water heater has keeps shutting off but will restate when reset button is reset, what is wrong:

State select electric hot water heater [ 1 Answers ]

I have a 4 yr old State Select electric hot water heater that is recently starting to trip the red reset button. Model #es652sort. It is set at the factory setting of 120 degrees. Could this be a thermostat problem and if so, what are the solutions? Thanks and I look forward to your response.

View more questions Search