I have a State Select electric water heater (M/N ES630DOLSG) that was not heating water. Then I was told A/C on top wet the electrical component and tripped the circuit breaker. Now its all dried out and breaker stays on but no water when faucets are turned to hot water side... all faucets and dishwasher not having any water. How do I reset? So the water heater will fill with water to heat and distribute? Thank you thank you

Do you have cold water coming through the tap ? Check your ground fault recp.

Are you saying that you have no water flowing out of the faucets or feeding the dishwasher? If that is the case then someone probably shut the cold water supply valve (see image) that feeds the water heater. Open the cold water supply valve on the cold water pipe and that should restore the water flow. You'll need to clear the hot water pipes of air by opening the hot side of the valves/faucets for a minute or so to get good, clean water flow.

Back to you...

Mark