Ask Experts Questions for FREE Help !
Ask
    mohow50's Avatar
    mohow50 Posts: 9, Reputation: 1
    New Member
     
    #1

    Jan 26, 2013, 01:33 PM
    98 Ford Windstar
    I have a 1998 ford windstar and mycheck engine light came on and the code was for the idle air control valve I replaced the valve and the reset the light but the light came right back on after driving a few miles then my transmiission would shift down ih to the first gear while I'm driving sometimes I can shift it to neutral and back to drive and it start shifting normally again something's it takes a while before it starts doing it and sometimes it won't do it at all what could be causing this
    mohow50's Avatar
    mohow50 Posts: 9, Reputation: 1
    New Member
     
    #2

    Jan 26, 2013, 01:40 PM
    Problems with a 1998 ford windstar
    What would make my 1998 ford windstar just suddenly shift into first gear while I'm driving and then sometimes drive and shift gears right my idle air control valve went out and then all this started
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #3

    Jan 26, 2013, 02:11 PM
    The MAF Sensor is likely failing. It needs to be replaced or it will destroy the transmission. Stay away from remanufactured MAF Sensors--my experience has been awful. I would install a new Motorcraft part--these sensors are sophisticated and crucial.

    If you want, check for codes/pending codes with an advanced scan tool. Don't overlook the possibility of a bad MAF Sensor connector. I've seen both the sensor and connector need replacing.
    mohow50's Avatar
    mohow50 Posts: 9, Reputation: 1
    New Member
     
    #4

    Jan 26, 2013, 02:25 PM
    Quote Originally Posted by TxGreaseMonkey View Post
    The MAF Sensor is likely failing. It needs to be replaced or it will destroy the transmission. Stay away from remanufactured MAF Sensors--my experience has been awful. I would install a new Motorcraft part--these sensors are sophisticated and crucial.

    If you want, check for codes/pending codes with an advanced scan tool. Don't overlook the possibility of a bad MAF Sensor connector. I've seen both the sensor and connector need replacing.
    Thank you what is a maf sensor and where is it located
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #5

    Jan 26, 2013, 02:32 PM
    The Mass Air Flow Sensor is located on the air intake. It will require a security Torx 20 bit to remove the screws. These sensors are very expensive--maybe even $300.
    mohow50's Avatar
    mohow50 Posts: 9, Reputation: 1
    New Member
     
    #6

    Jan 26, 2013, 05:18 PM
    Quote Originally Posted by TxGreaseMonkey View Post
    The Mass Air Flow Sensor is located on the air intake. It will require a security Torx 20 bit to remove the screws. These sensors are very expensive--maybe even $300.
    Thank you very much for your advice I did what you said and it resolved my problem again thank you and God Bless YOU there should be more people like you around
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #7

    Jan 26, 2013, 06:15 PM
    Very nice job--you wasted no time whatsoever. From experience, I can say your situation can be a very difficult one to troubleshoot. You saved yourself a lot of money.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #8

    Jan 26, 2013, 07:17 PM
    P.S. The automatic transmission is the weak link on Windstars. Every 30,000 miles, be sure to drop and clean the transmission pan and magnet, replace the filter, and refill with Mercon V ATF. You can increase the margin of safety by using Mobil 1 Synthetic ATF.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1999 Ford Windstar [ 1 Answers ]

1,2,D don't work but the upper gears seemed to work, once I got up to speed. Any suggestions?

200 ford windstar [ 2 Answers ]

I changed the fuel pump on my 2000 windstar and it still will not turn on.It cranks but will not start

Ford Windstar-Transmission [ 22 Answers ]

Hello Everyone:) I was on my way too the grocery store, when the my windstar van suddenly died? No hints to help me diagnose. No codes from my OMD II (is this right?) that my dad had bought for my birthday. It won't go into R, D, 1,2, despite starting and reving with no problems. I wish I could...

Ford windstar trouble [ 2 Answers ]

I have a 2000 windstar with a few concerns. My back brake light gets stuck and stays on after I shut off the engine and have to play with the brake to unstuck the lights. Sometimes when I try locking the door the lock just pops back up when I close the door. And I noticed yesterday the...


View more questions Search