Ask Experts Questions for FREE Help !
Ask
    larry1097's Avatar
    larry1097 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 22, 2013, 05:56 PM
    Janitrol furnace problems
    Draft inducer runs then ignitor glows gas comes on and burns for just about a second then everything stops. Starts all over and then in starts fine.
    endent's Avatar
    endent Posts: 13, Reputation: 2
    New Member
    		  
    #2

    Jan 24, 2013, 10:58 AM
    Start with cleaning the flame sensor.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Janitrol furnaces problems [ 2 Answers ]

Janitrol furnace pilot starts the furnace but doesn't stay lit. then cycle starts all over. What's the problem?

Janitrol furnace [ 1 Answers ]

I have a janitrol furnace serial # 6491074 size UA585-14. We have to push in and hold the (ignitor?Pilot?) button for several minutes before it will stay lit. Then it seems after it runs for a bit, the pilot light is still lit, and the fan is still running, but it won't blow warm air anymore. What...

Janitrol furnace [ 5 Answers ]

I hit the power on my furnace and the board hums for a few seconds and then blinks three times . Ihave checked for blockage in vent and is fine. Ihave blowed pressure switch and it clicks is it the switch board or air blower that won't start.

Janitrol furnace problems [ 13 Answers ]

I have a Janitrol furnace that is 10 yrs old. It hasn't put out near the force of air as it used to, and now it cycles out and doesn't bring the temp up to the thermostat temp. I have to turn the thermostat off and back on to get it to run more than once in awhile. It does do better if I take...

Janitrol Furnace [ 5 Answers ]

Hello - I have a Janitrol Model # GUE060-E Furnace. The blower will not shut off unless I power it off by removing the bottom panel. I hear a clicking sound like it wants to shut off. The thermostat is set to auto mode. Could it be the relay? Thanks, Dan

View more questions Search