 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Carrier furnace 58mca080
I have a carrier furnace that refuses to light. I light momentarily with a lazy flame. It eventually trips the temperature switch. I thought it may be the valve. Changed it, not it. Blew out all the air lines, no luck. Changed combustion motor. Still not happening. Took off parts and put them on another unit. All checked out fine. Pressure switch, new. Flame sensor, new. I don't like being a parts changer but this one has got me. Vent piping has been cleaned. Any ideas?
|
||||
Check out some similar questions!
Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?
My carrier infinity gas furnace goes on and off mmany times before it reaches the set temp. It has a two stage blower motor. The unit is only three years old. Board and thermostat have been replaced.More intake ducts added. None of this helps
I have a 58rav115-16 caarrier unit. Lst week I replaced a suspected bad draft limit switch(code31) ran fine after. This morning I got up and the blower was running but it would not ignite. I switched to emergency heat and received a code31. I bypassed the draft switch and was able to get the them....
I have a 80% Carrier furnace! I have to shut off the power some times for it to start up again! Then I have to turn the thermostat way up for it to go!! Do I have a bad stat or do I need to replace the ignighter and or the glow plug?
I have a Carrier Furnace that will not light. It has an electronic igniter. I turn the power off and on and the blower works but it will not ignite. It cycles two or three times and turns off. It has a red light that blinks on and off intermittently.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
