Ask Experts Questions for FREE Help !
Ask
    Kyle_in_rure's Avatar
    Kyle_in_rure Posts: 341, Reputation: 10
    Full Member
    		  
    #1

    Jan 15, 2013, 06:07 PM
    Trouble resetting circuit breaker
    Hello,
    I accidentally turned off a 40 amp double pole water heater breaker when I was trying to turn off a different circuit in an old Cutler-Hammer panel. I attempted to reset it 3 or 4 times; it would 'click' on and then trip instantly. I tried it again in 15 minutes and it did the same thing. Finally I tried over an hour later and it reset fine. My question is, is this likely a water heater load issue or just a bad breaker?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jan 15, 2013, 07:07 PM
    Sounds like a weak breaker to me. Was the heater drawing power when you did this? Did you try resetting with the heater turned off/down
    Kyle_in_rure's Avatar
    Kyle_in_rure Posts: 341, Reputation: 10
    Full Member
    		  
    #3

    Jan 15, 2013, 09:34 PM
    I'm not sure, and no I did not try that. The heater is not easily accessible. If it happens again I'll change the breaker.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #4

    Jan 15, 2013, 09:35 PM
    I would too, its not very expensive. Anytime I see a breaker acting funny I swap them out tobe on the safe side
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #5

    Jan 16, 2013, 03:32 AM
    The breaker should hold or reset with or without load. The CB is defective, not going to get better on its own, why wait, change it now.

    Good time to confirm, since it is a 40 amp CB, it should have #8 wire for the branch circuit.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Theory of vacuum Circuit Breaker & sf6 circuit breaker [ 15 Answers ]

I want to know about the basic Theory of vacuum Circuit Breaker & sf6 circuit breaker

Why vacuum circuit breaker is prefer on oil circuit breaker ? [ 1 Answers ]

Why vacuum circuit breaker is prefer on oil circuit breaker ?

I have a Murray circuit breaker panel and want to add a circuit for a 3 prong elec dr [ 3 Answers ]

I have an electric 3 pronged dryer that I want to add a circuit for on my Murray Circuit Panel. What kind of switch do I need?

Resetting Trouble Maintenance light for 2008 Volvo, VS70 [ 2 Answers ]

I serviced this car for 80,000 miles and disconnected the negative terminal of the battery but the trouble light comes back. Does anyone know to reset so it does not come back on or I have to pay the dealership to reset it?

Light sockets keep resetting breaker [ 5 Answers ]

Hi All, I have a bathroom socket that periodically trips the breaker when a portable heater is used. One of my outside covered sockets is on the same line and occasionally tripped the breaker when we had the pool pump plugged in. Sometimes all I needed to do was press the reset button on the...

View more questions Search