Ask Experts Questions for FREE Help !
Ask
    arrr_geee's Avatar
    arrr_geee Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 8, 2013, 04:13 PM
    Top mount sink clips
    Hello -

    My topmount sink has 16 clip slots - 8 sets of 2. My contractor used only 8 clips (1 clip for every set of 2. Is this accepted as standard practice? The sink seems to sit flush with the counter and is secure, but I want to be sure it's stable for many years to come.

    Thanks
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Jan 8, 2013, 05:27 PM
    Hi AG

    8 clips isn't ideal, but if the sink is down tight and secure I'm pretty sure you will be fine!

    Mark
    arrr_geee's Avatar
    arrr_geee Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jan 9, 2013, 09:16 AM
    Thanks for the reply, Mark.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #4

    Jan 9, 2013, 10:05 AM
    Glad to help!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can't get clips on dryer top to disengage [ 0 Answers ]

I have a front load dryer, specifically a Frigedaire Model #GLEQ2152ES1. The dryer has developed a high-pitched squeal. After researching common problems and suggestions on this forum, I have purchased the rear bearing assembly kit. After disconnecting the power source, I have been attempting to...

How do I the top of the agitator back on so it will stay without breaking the clips? [ 0 Answers ]

Kenmore washer with Calypso, Model number 110.2206

Maytag Performa Top Mount Refrigerator not cooling [ 3 Answers ]

My 2001 Maytag Performa fridge has decided to give up it's job of cooling. The symptoms are: The freezer is not freezing. It seems to be stuck at about +6 deg C. Also the main fridge compartment is up to about +10 deg C. I don't know if these are stable temperatures or just the temperatures that...

Replacing top-mount compression faucet. [ 6 Answers ]

Hi: I am going to try (first-ever attempt) to replace my top-mount compression faucet (4" Centerset) in the bathroom sink. Anybody have a good set of instructions and/or tips? I have already sprayed WD-40 to the lock nuts under the sink since they are extremely rusted... planning on keeping...

View more questions Search