Ask Experts Questions for FREE Help !
Ask
    kahler33's Avatar
    kahler33 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 4, 2013, 08:01 AM
    Furnance/thermastat temp
    I have temp in my house set for 72 degrees (small baby). Sometimes I wake up in the middle of the night or just in the morning and the temp in the house is 69 degrees! Why hasn't the furnace kicked on? Bad thermastat or is it something with my furnace?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
     
    #2

    Jan 4, 2013, 06:00 PM
    First of all, 69* isn't going to hurt the baby. Some thermostats are not that accurate. I have seen them off by as much as 5 or 6 degrees. This is especially true for non digital stats.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gas furnace won\'t reach temp. on thermostat [ 1 Answers ]

I have gas furnace that will not reach temp. set on thermostat. I put new batteries in thermostat and change my air filter and I also had a furnace check in fall. The temp. is set to 90 degrees and it only reach 71. What else can I do?

My 1998 chevy venture temp gauge keeps redlining then dropping below normal temp. I h [ 1 Answers ]

My temperature gauge keeps redlining then dropping below normal operating temp. I had my thermostat replaced, still happens, flushed rad and added head gasket repair (liquid) and ran as directed heater on full. Tenp gauge stays low while driving with lots of heat but when idle at light temp gauge...

A small indoor pond (approx 30gal) room temp is 70 C. What's the water temp? [ 1 Answers ]

I'm putting goldfish in a pond and need to make sure the temp is adequate for their survival. The room is a approx 30 x50ft 20 ft ceiling. The amount of water is the only thing I'm unsure of, but it's approx 30-50 gal.

Heat not kicking on until the temp dips below 64 degrees, target temp set to 72 [ 2 Answers ]

Hello, This is my first time posting here, but I figured it was a good place to start for some advice. I just bought a new townhouse a few weeks ago and have been having some heating issues since moving in. The actual furnace (Goodman GMS 8045) was installed in June of '06 while the unit was...

Furnace not kicking on when temp drops below thermostat set temp [ 1 Answers ]

I've got a Beckett oil heat water on demand furnace that heats through baseboards. Since this past weekend the furnace hasn't been kicking on when the temperature drops below my set temp of 68 degrees. I have to go down to the furnace and simply touch the top of the reset box for it to kick on. ...


View more questions Search