 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman Furnace
We have a Goodman 3 ton unit, approximate one year old. It seems to run in short cycles when heating. About one minute each. And the blower motor is continually running. The problem is it not delivering the heat. Any help would be appreciated
|
||||
Check out some similar questions!
I have a GMNT-080-4B Some times I get a 3 blink light issue and then when it starts it has a flame roll back. Also I have to change the ignitor every year. Any help would be great
On my 15 yr old Goodman GMP050, the preigniter stays hot orange even after the furnace cycles properly. I've sanded the flame sensor and the igniter but it still stays on till I shut off the electricity at the furnace. Any thoughts? It's COOOOOOLLLLLLDDDDDDDDD!
I have a goodman gmp 100 4 It doesn't matter if I have the ac or furnace on it comes on goes off even when I total disconnect the thermostat I had the wires sticking from the wall the unit still came on if I place the unit on the off it still comes on but ont the furnace blower I was told that I...
I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...
My furnace is pulsating, gas valve is clicking on and off rappidaly, I shut it off for a short time then it will work for a few hours then start acting up again installed new air pressure switch no change,do you think I should replace the flame sensor.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
