Ask Experts Questions for FREE Help !
Ask
    pastor1189's Avatar
    pastor1189 Posts: 1,538, Reputation: 3
    Ultra Member
    		  
    #1

    Dec 23, 2012, 07:32 AM
    Protective washer after drilled holes
    After your drill a hole. There is some sort of protective rubber or plastic grommet you insert into the hole. As if it would be protecting damage made by pulling a wire or rope through the raw hole.
    Do they have a name for it. Is it found in the electrical section?
    Or what do the call it?
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Dec 23, 2012, 07:44 AM
    metal stud snap in bushing electrical - Google Search
    And:
    http://www.sustainablesupply.com/Arl...26&cagpspn=pla

    A couple of examples, Merry Christmas.
    pastor1189's Avatar
    pastor1189 Posts: 1,538, Reputation: 3
    Ultra Member
    		  
    #3

    Dec 23, 2012, 08:25 AM
    That is exactly what I mean. Merry Christmas too
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search


Check out some similar questions!

My knits come out of the washer with holes. What is causing this? [ 3 Answers ]

I have a Kenmore Elite QuietPak 4 front load washer. When I wash my knit clothing, they often come out of the wash with several tiny holes in the front. This has happened on numerous occasions. What could be causing this?

I drilled several holes in pvc drain pipe [ 4 Answers ]

I drilled several holes in pvc drain pipe behind wall. I read some forums and they mentioned taking the same size pipe and cutting out a patch. You then glue it an clamp it. My worry is that ID and OD of pipe is different. Is this the best way or how should I fix these holes. My studfinder...

I'm having big problems with my drilled well. [ 1 Answers ]

I need to know if I've got shafted or not? From an expert in the field of drilled wells? I had a 6in well put on my land with a half horse in well pump and pessure tank in the well. Cost me a bit over $5000.00. Well three years later we built our house on the lot about 140' from the well. Since...

Drilled into PVC Pipe [ 2 Answers ]

While drilling a hole to hang a towel rod in a first floor bathroom, I drilled into the PVC waste line that comes from the upstairs bathrooms. I cut away a section of the drywall and can see I hit almost dead center into a 2 or 3 inch PVC waste line. The hole is approx. 1/2" in diameter. Is there...

Drilled Wire [ 1 Answers ]

I nicked an electric wire with a drill bit mounting a shelf on the wall, it blew a breaker. I have reset breaker and the circuit is working fine. Should I tear into wall and repair the wire? Thanks for any suggestions John

View more questions Search