What type of blower motor for york diamond 80

kienhoaca Posts: 1, Reputation: 1

New Member

Dec 18, 2012, 12:10 PM

What type of blower motor for york diamond 80

My york furnace diamond 80 everything look like work fine except blower not running at full speed and shutdown after 40 second

ma0641 Posts: 15,675, Reputation: 1012

Uber Member

Dec 18, 2012, 12:43 PM

Try replacing the start run capacitor.

Add your answer here.

Check out some similar questions!

York Diamond 80 heat blower cycles 20 seconds [ 9 Answers ]

Hi, I have a 1996 York Diamond 80 furnace. Everything starts up OK (thermostat fine, flue fan kicks on fine, then pilot orange glow, then click, then gas burners fire up, then main blower fan starts). This all happens in about a minute or so, but then the main fan only runs for 22 seconds, then it...

York Diamond 80 Gas furnace (main blower stopped in 2 minutes and never come back) [ 2 Answers ]

I inspected the furnace and found it starts normally (frame, main blower, another motor on top of furnace... etc.) initial time but main blower stopped after 2 -3 minutes even though frame (fire) is on. Frame went out 1-2 minutes after main blower stopped. Frame is continuing to on and off but...

15 year old York Diamond 80 furnace: no power to blower [ 0 Answers ]

Igniter works, gas comes on, no power being sent to blower motor when when it's time for the blower motor to come on. I can hear the solanoid click, but when I test across the leads going to the motor, no power present. Any advice would be greatly appreciated.

Inducer Motor on York Diamond 90 Keeps Running [ 4 Answers ]

I recently had the inducer motor replaced when it burnt out but I am having issues again. The inducer motor keeps running and won't stop until the whole system shuts down. Let me correct myself. I actually am reading about 26 V on the terminals of the pressure switch. The voltage on the...

York diamond 80 blower works but no heat [ 1 Answers ]

the blower turns on and blows cont. but the burners don't kick on the blinking red light on the box blinks 4 times = high linit switch on