Ask Experts Questions for FREE Help !
Ask
    tfzimmerman's Avatar
    tfzimmerman Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 9, 2012, 12:38 PM
    How do I add another switch and fixture to a switched light circuit
    I have a kitchen light that is currently on a single-pole switch, with power entering at the switch and two-wire w/ground Romex going to the light. Can I safely add another switch and, using the existing cable in the wall and ceiling, power another separately-switched fixture? If so, can someone send me a wiring diagram? Thanks!
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
    		  
    #2

    Dec 10, 2012, 02:47 AM
    If adding a switch to existing switch box, you can power up the new switch with existing power, but you will have to run a new cable to get power to new light.

    Chuck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to change a pull chain fixture to a fluorescent light fixture with a switch ? [ 1 Answers ]

I would like to install a switch for a pull light fixture. The only power is from the light fixture, but I want to put a light switch on the wall as I enter the room, Can you help ?

How do I add a light fixture to an existing switch? [ 1 Answers ]

I want to know how to add a new light to an existing light switch? There doesn't look like there is enough room in the box to add any new wires, and I don't want to over load it. How many lights can you run off one switch?

Pull switch installed on a switched light? [ 1 Answers ]

Hi: I would like to install a pull switch into a fluorescent light (one ballast) that is controlled by a wall switch. The flouescent light is at the end of the another light that is controlled by the same wall switch. Can I switch this fluorescent light from the pull switch? I understand...

Circuit breaker tripping when light switched on. [ 32 Answers ]

I just installed a chandelier light fixture to a pre-existing junction box in my condo. When I flip the electricity back on for the room however, the fixture lights up in spite of the light switch being in the OFF position. When I flip the light switch to ON, the breaker trips. Is the problem...

Adding another switch leg to a 4way switched light [ 5 Answers ]

OK, the walls were open when I did this so hopefully I got the right wire types in before I closed her up! I have a dining room with 4 entry points and I've put a switch box at each location. The power is fed to this lighting circuit through the room lights junc. Box. I ran a 2 plus ground...

View more questions Search