Check out some similar questions!
Control board for goodman gmp075-3 furnace serial number0005601329
[ 0 Answers ]
I have a goodman gmp075-3 furnace serial number 0005601329 that will not start up. I have done some troubleshooting as outlined below: 1) turn thermostat up and exhaust motor comes on. Igniter does not glow and furnace light on board flashes 5 times. 2) Checked and am not getting 24V to gas...
Trane xe80 control board failure replacement
[ 0 Answers ]
I have just replaced my TRANE XE 80 control board and the fan comes on immediately and the LED blinks 5 times. I have checked all the rollout sensors and the fan and blower sensors and they are good. I have jumped all the sensors out at the control board and still get the same result. I have...
Trane xe80 internal control board failure, red light on steady
[ 1 Answers ]
Trane xe80 internal control board failure, red light on steady
Trane xe80 internal control board failure, red light on steady
[ 0 Answers ]
My furnace runs for a while then the flame goes out but the blower keeps running. Control board has solid red light that means internal control board failure (replace)I turn off the power to the unit and then turn back on, it runs for a while then repeats. Seems to get worse the colder it is outside
Lennox control circuit board failure?
[ 0 Answers ]
I have a Lennox G40UH system that is not engaging the inducer motor. I swapped out the inducer and the pressure switch from the downstairs unit and I'm still not getting any power to the inducer. Is there another way to verify if the ignition control circuit board is faulty? View more questions Search
Add your answer here.
|