Ask Experts Questions for FREE Help !
Ask
    reyregaspi's Avatar
    reyregaspi Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 1, 2012, 09:36 AM
    Trane Gas Furnace XE80 Troubleshoot
    I have an xe80 gas furnace heater turns on but no heat and fan keeps running cold air. What's wrong with my furnace?
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Dec 2, 2012, 08:36 AM
    These furnaces are very simple appliances. There is a circuit to prove the pilot light and it depends on a clean flame rod. It looks like a platinum spark plug on one end that has the thin platinum rod extending into flame. When it gets dirty it will not sense any flame and will shut off gas valve. Turn off power and pull out burner assembly and clean it all out. All you do is to disconnect the things attached to the burner and lift it out where you can see what you are doing. Get it all clean and vacuum out the heat exchanger and all around. After reassembling check it out and see what is happening. You are going to have to use a meter to get anywhere because in a few minutes you should find the problem. Check your fan relay and t-stat and see if the relay is stuck or it's sending power from t-stat to fan relay coil (24v). Here are some booklets to help: https://dl.dropbox.com/u/8010163/How...e%20Manual.pdf
    https://dl.dropbox.com/u/8010163/AC%...20Diagrams.zip
    https://dl.dropbox.com/u/8010163/Mak...Appliances.zip
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane xe80 gas furnace not blowing any hot air [ 2 Answers ]

I have a Trane XE80 Gas Furnace. It is not blowing any hot air at all. Can anyone help. Thank you

I have furnace Trane xe80, could not start,fan not working [ 0 Answers ]

I have furnace trane xe80, could not start at all. I try fan did Not start also. I switch termostat to cool ,just to check out,does not start either,fan does not worked.

What do five blinking red lights mean on a xe80 trane furnace [ 1 Answers ]

I have a XE80 furnace (installed sept.1995) the light blinks five times. The thermostat is off but a fan motor comes on that can be heard at the return vent.

Electric trane xe80 furnace cold air? [ 1 Answers ]

I have a tranex e80 electric furnace Model vcm 15uls 115v-60hz 1.0a 1 phase The furnace is only blowing cold air. I have tried reseting it and no luck. The error code is 22 but there is no codes listed on the furnace & do not know what the trouble code means. The system cuts on, fans blow & you...

XE80 Trane Furnace-no ignition of gas [ 1 Answers ]

I have furnace that calls for heat from thermostat, ignition coil(stick) lights up, sometimes I get gas ignition and sometimes not, then the gas shuts down. The blower motor continues to run. I cleaned the temperature sensing rod. The control board lights up with the message "Internal control...

View more questions Search