Ask Experts Questions for FREE Help !
Ask
    Pasqinel's Avatar
    Pasqinel Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 13, 2012, 12:48 PM
    General controls b67 gas valve replacement
    Hi. I just had my Empire direct vent wall heater connected (finally) after being installed for 10 yrs, but not being used. Didn't need it. Now I do. However, after lighting the pilot, the darn burner won't come on. It uses an ITT Gen. Controls B67 control valve. Took the orifice out and checked it for spiders and dust. Was wide open. Don't have a milivolt tester. The dial knob on the valve isn't stuck or tight; it releases easily after lighting the pilot and turning to "on" position. It's virtually a "brand new, 10 yr. old valve" that won't open. Any thoughts? I can't even locate a B67 valve; guess they've been updated, but I don't know what replaces it.
    Thanks for your time.
    Bill Mitchell

Check out some similar questions!

Itt general controls [ 2 Answers ]

I have an old heater. The label underneath the case states Model G-36-S.D. input rating--35,000 BTU; output rating--24,500 BTU; equipped for use with natural gas. Holly Division of Leah Siegler, Inc. The unit (I believe it's the heater looks like it was replaced with another unit. The small unit...

ITT General Controls thermostat went out [ 5 Answers ]

Hi everyone, I stumbled across this site today after my thermostat went out. It's a T80BV100 ITT General controls thermostat. I disconnected it from the wall and exposed two black unlabeled wires. For the record it says for use with millivolt and B54M gas valve only. My question is...

General controls gas valve? [ 2 Answers ]

I have a General Controls B60Y64A123 Gas Valve on my Gas Furnace. I am replacing the Thermpile, but I am not sure what the Alum. Tube coming out of the gas valve and positioned next to the pilot is for. Please explain and does the end of the tube go in the flame or close to the flame. My gas valve...

Can this old General Controls millivolt gas valve be replaced? [ 3 Answers ]

I have an old General Controls millivolt gas valve: Https://picasaweb.google.com/112652995081934659158/GardenHeating#5515080849589233618 The valve is starting to operate erratically (sometimes does not come on until I tap it). Can someone recommend a replacement? Thanks.

ITT general controls gas valve with a Honeywell TS810B1007 [ 0 Answers ]

Pilot light is on but it will not turn on via the thermostat. What should I look for?

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.