 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Waltec shower knob
I am trying to remove a Waltec 20 single shower knob. I am down to the threaded nylon part that is attached to the back brass ring. What do I do from here, does the nylon part screw out of the brass ring or does that brass ring get screwed off? Neither part seems anxious to separate from where they currently are attached.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Replaced washers. How do I replace the seats
My shower has two handles, one for hot and one for cold water. This morning when I turned the hot water knob off after my shower it worked fine at first but then the handle started to feel like it was turning really loosely and it never came to a hard stop (it kept spinning in the same direction as...
How do I disassemble a shower knob
Hello. My hot water shower knob has been stuck for months and the only way I can turn it is buy using channel locks. Though I don't think this has anything to do with it, the knobs themselves used to fall off all the time, and so during a weak moment I epoxied them into place. I know, not a...
Is there a trick to removing the control knob in shower. I know there is a cover plate, I just can't figure out how to pop it off. Do I need a special tool to get that plastic cover off. I tried a flathead screwdriver, but the tip is too fat.
View more questions Search
|
