Ask Experts Questions for FREE Help !
Ask
    shaunastueve's Avatar
    shaunastueve Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 11, 2012, 07:10 AM
    Reset code for kenmore ultra wash 280-2
    Reset code for Kenmore Ultra Wash 280-2. Start button flashing. Lock button on. Holding down heated dry doesn't unlock it.
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Oct 12, 2012, 08:53 AM
    See if this repair manual helps: https://dl.dropbox.com/u/8010163/Ken...Dishwasher.pdf
    You need to check out the dishwasher to find out why it will not run. It could be the high water float stuck, for example, or a stopped up filter or drain.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore ultra wash dishwasher reset button? [ 3 Answers ]

Our model 66516039401 Ultra Wash Kenmore had the clean light flashing so I followed instructions to the point where every single light on the control panel lit up. Now it is absolutely dead... I can't get any lights to come on at all. I unplugged it for a while and it was still dead so I tried...

Kenmore ultra wash 665 latch reset [ 0 Answers ]

Is there anyway to unlock the latch on my kenmore ultra wash 665.1329 dishwasher?

?how to reset kenmore ultra wash dishwasher 665.17772990 [ 0 Answers ]

My ultra wash was flashing "Lock On" I changed the circuit board. Now it flashes "Quick Rinse". Is there a way to reset the system?

Kenmore 6651355 ultra wash reset [ 0 Answers ]

I can not tun on my dishwasher. I have tried reset by switching between high temp and heated dry until all lights illuminate and runs through each cycle briefly. I then attempt to run normal wash and no response. There must be a specific sequence. The owners manual is no help! Any thoughts on this

View more questions Search