Ask Experts Questions for FREE Help !
Ask
    leonleoj's Avatar
    leonleoj Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 28, 2012, 06:29 PM
    Airco 2-Stage furnace cutting out at 2nd stage
    I have an Airco 2-Stage furnace that was working fine with a Lux thermostat. I changed the thermostat to a Honeywell WiFi thermostat so I could control it remotely. After installing the thermostat based on the install instructions it weemed to work fine until the 2nd stage kicks in on the furnace. When the 2nd stage kicks in the furnace cuts out or powers down. The furnace then comes back on by it self but it starts again at stage one and then will cut out again when/if it has to go to the 2nd stage. I used a 'G' wire bypass on the thermostat install because the thermostat requires a 'C' wire for power and there wasn't one. (not sure if that has anything to do with it. I called Honeywell and they said it is wired correctly according to the Honeywell thermostat specs.

    Any ideas?
    Thanks.

Check out some similar questions!

Two stage heat pump with two stage furnace and only three stage thermostat [ 4 Answers ]

I had an Amana two stage heat pump installed with a Goodman two stage gas furnace. I have a Comfortnet thermostat and it omly uses the two stage heat pump and high side of furnace. What is the use to have a two s two stage furnace.

Does my bryant 8oplus 2 stage furnace need a 2 stage thermosta [ 0 Answers ]

Model is 312aavfurnace --563cnxo3600 ac unit &

Two stage vs single stage heat pump compressors- How much energy does a 2 stage save? [ 1 Answers ]

I am comparing 5 ton heat pumps; some with 2 stage compressors and some with single. Does the two stage really save that much energy when on a 5 ton compressor? Is it worth an extra $1200?

Hvac1000: Or ing stage relays (multi-stage stats to single stage) [ 1 Answers ]

Would you agree that you can and should OR the outputs of say a 2 stage heating stat to make it a single stage? OR means connect the outputs together. Example: Connect W and W2 to create a single stage stat. I'm under the impression that either W1 or W2 is activated and not both and that this...

2 stage furnace / single stage thermostat [ 1 Answers ]

I am having a Goodman 90,000btu 2 stage, variable speed 5 ton blower furnace put in. I am also have a 3 ton 16 seer A/C put in. They want to set me up with a Honeywell 4000 programmable thermostat. I thought that I read that this thermostat was for single stage heating. Am I getting short changed?...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.