Ask Experts Questions for FREE Help !
Ask
    hedison's Avatar
    hedison Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 25, 2012, 12:59 PM
    Low water flow after changing valve assemblies
    I have double faucets Hot & Cold) in my bathroom. After the hot side water flow was very low before changing out the valves. But after changing the, The water flow through both sides is barely beyouns a trickle. I Shut off the water to the sink on the other side of the bathroom to see if the flow would increase on the other side. There was no improvement.

    Can you direct me topotential causes?
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Sep 25, 2012, 05:51 PM
    So is the hot and cold flow poor now? If so, I would suggest removing the fuacer aeorator and cleaning or replacing it. Better now?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Have to turn off main valve on a low flow toilet to get it to work. [ 1 Answers ]

As I stated in my summary we have a low flow valve on our toilet the only way we can get the tank to fill is to turn off the main valve then turn it back on to get it to flush It's called hydro flush on Amazon if that helps

Very low gas flow from home NG to bbq... shut off valve, quick-connect problem? [ 5 Answers ]

My natural gas bbq (NOT propane) no longer makes enough heat, so I've done the following: 1) remove burner tubes and ensure they were clear (they have spider protection covers and were clear 2) reassembled and ignited... VERY small flames came out of all 3 burners 3) removed flexible rubber supply...

Changed valve on Hotwater tank leads to low flow [ 1 Answers ]

I have a 40 Gallon Natural GAZ "GIANT" hot water tank. The Cold water in valve was leaking so I changed the piece. I made sure that the everything was clear and clean and that the valve was a BI-Directional flow. The tubes are PEC and I crimped the O-rings into place and they are a GO. ...

Low Pressure and Low Flow Water Supply [ 4 Answers ]

I recently moved into a house that is about 6 years old. The house sits upon a small hill. The water pressure is 40 psi at the street and the flow rate is 13 gpm. At the house, the pressure is about 30 psi and the flow rate is 3.5 gpm. The house is higher than the street level, but the...

View more questions Search