Ask Experts Questions for FREE Help !
Ask
    JuneP's Avatar
    JuneP Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 22, 2012, 06:45 AM
    Evcon gas furnace trouble shooting
    The indicator lights blink 3 times, which says that the centrifugal switch is stuck open. I have located the centrifugal switch, and with power off, have gently tapped to free, which apparently has not worked. This is an Evcon propane gas furnace. I have the thermostat all the way up, power is currently turned off.
    What do I do next?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Sep 22, 2012, 09:03 AM
    The centrifical switch should be part of the motor. What's the model number of the furnace?
    sheilathomas's Avatar
    sheilathomas Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Feb 19, 2013, 12:23 PM
    The DGAH model
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rheem gas furnace trouble shooting codes? [ 0 Answers ]

Is there a manual of trouble shooting codes for Model# RGDG-15EARJR - THE FURNACE IS DOING A DOUBLE FLASH AND WON'T IGNITE I can be emailed at [email protected]

Trouble shooting 95% Goodman gas furnace? [ 0 Answers ]

GMH950904CXA. When the blower comes on the burners start to afed like the wind is blowing on them and the roll out switch shuts down the 24 volt's. Checked for CO found 0 PPM in house at regesters. Furnace is three yr's old in horrizonal position. Never seen this before. Any Ideas.

Trouble shooting-Centurion gas furnace [ 0 Answers ]

Have rheem centurion gas furnace- lights- but won't stay lit- any suggestions? Important #'s:letters: RGPJ1ONBRJR And EB5D307F449900215... any help would be greatly appreciated. Brrrrrrr.

Maytag gas drier trouble shooting [ 0 Answers ]

My drier will not heat. I have removed the front panel and set the machine to run. The igniter does not come on. I have check it with a vo meter and it has continuity. What should I be checking?

Furnace Trouble shooting [ 1 Answers ]

I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...

View more questions Search