 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trouble shooting 95% Goodman gas furnace?
GMH950904CXA. When the blower comes on the burners start to afed like the wind is blowing on them and the roll out switch shuts down the 24 volt's. Checked for CO found 0 PPM in house at regesters. Furnace is three yr's old in horrizonal position. Never seen this before. Any Ideas.
|
||||
Check out some similar questions!
I have a Goodman GMPN060-3 gas furnace. My ignitor will glow and ignite the burner but will go out in just a few seconds. I have replaced the ignitor but still have the same problem. The furnace will try to ignite three times before shutting down. Sometimes it will ignite and continue burning on...
Have rheem centurion gas furnace- lights- but won't stay lit- any suggestions? Important #'s:letters: RGPJ1ONBRJR And EB5D307F449900215... any help would be greatly appreciated. Brrrrrrr.
Hello I have a Altra 90 SX Armstrong furnace that has a cycle problem. The model # is a GUK75D103A with a Heatcraft control board 404030001 Cat. # 70K98 The problem that I'm actually having is that it is going through its cycles OK, except the induced fan keeps running and won't shut off. ...
I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
