Ask Experts Questions for FREE Help !
Ask
    Tom19's Avatar
    Tom19 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 21, 2012, 11:13 AM
    How to wire in a thermostat on a Bryant furnace, on the control board I have terminal
    How to wire in a thermostat on a Bryant furnace, on the control board I have terminals W, Y, R, C for 24 volt common & G and on the thermostat I have terminals W, Y, R, G. Thank you Tom.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Sep 21, 2012, 06:18 PM
    Presuming you have Red, White, Green, & Yellow wires going to the stat, wire it & the board color for color. There would also be wires from C & Y on the board to the outdoor unit of the A/C.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier/Bryant Furnace control board . [ 9 Answers ]

I replaced Carrier/Bryant board and the led is flashing rapidly.. what can be wrong? It looked like there's problem with polarity,but everything is fine, the led is still flashing.. uff.. Led Code: Continuous on rapid flashing-Line voltage 115 polarity reversed.If twinned,refer to twinnig kit...

Furnace control board wiring and thermostat? [ 0 Answers ]

With the help of a neighbor, I just installed a new blower motor on my furnace. Furnace is located in crawl space and AC unit is on side of house. We feel confident we wired the motor correctly. However, on the main panel/wiring panel/sensory panel, White Rodgers 50TC35-730 there is a scanner...

Were do the wire go from the motor to the board on a Bryant 90 plus furnace [ 0 Answers ]

BRYANT Furnace blowing 3-amp fuse on control board [ 1 Answers ]

I have a Bryant M/N 383KAV036070AGJA, S/N 3097A08913, Series G furnace with central air that is blowing the 3-amp fuse on the control board. The furnace has been serviced numerous times over the past two years for various problems by multiple service companies. The control board was even replaced...

Powering the G terminal on my furnace control board [ 1 Answers ]

Hi! My furnace's control board recently blew and the repair guy replaced it with a different kind. Aparently the new board requires a wire from the thermostat to the G terminal to work the A/C fan, and the old one didn't. The repair guy would need to make another trip for this repair. I am...

View more questions Search