 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I replaced Carrier/Bryant board and the led is flashing rapidly.. what can be wrong? It looked like there's problem with polarity,but everything is fine, the led is still flashing.. uff.. Led Code: Continuous on rapid flashing-Line voltage 115 polarity reversed.If twinned,refer to twinnig kit...
Hello, I have a Bryant furnace. It keeps flashing code 13 on the circuit board. I read the code and it says that the switch will reset after 3 hours. It also refers me to # 33 which gives more possibilities as to what the problem may be. However it does say to reset the limit or flame roll out...
Bryant furnace model 394gaw blew the circuit board two days ago. I just replace it, but the unit does not turn on? I switched the wires very carefully. What else could have happened? Just a quick question.
I have a Bryant M/N 383KAV036070AGJA, S/N 3097A08913, Series G furnace with central air that is blowing the 3-amp fuse on the control board. The furnace has been serviced numerous times over the past two years for various problems by multiple service companies. The control board was even replaced...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
