 |
|
|
 |
New Member
|
|
Jan 9, 2011, 06:05 PM
|
|
Electrical questions free?
Why does an afci trip when the neutrals of two different afci circuits are tied together in a switchbox?
|
|
 |
Uber Member
|
|
Jan 9, 2011, 06:30 PM
|
|
Since an AFCI and a GFCI work on relatively the same basic principle, i.e.unbalanced current flow, tying 2 neutrals together from 2 different circuits makes the circuit think it is unbalanced and trips.
|
|
 |
Electrical & Lighting Expert
|
|
Jan 9, 2011, 07:21 PM
|
|
 Originally Posted by ma0641
Since an AFCI and a GFCI work on relatively the same basic principle, i.e.unbalanced current flow, tying 2 neutrals together from 2 different circuits makes the circuit think it is unbalanced and trips.
I fully agree.
I hope this is a rhetorical question. You should never tie the neutral from two different circuits together.
|
|
 |
New Member
|
|
Feb 23, 2011, 09:28 AM
|
|
Can I derive 120v for a light from a 240v line feeding a spa? Or do you recommend running a separate line.
|
|
 |
Printers & Electronics Expert
|
|
Feb 23, 2011, 12:18 PM
|
|
No you cannot. The 240V circuit is a dedicated circuit and cannot be tapped for a 120V circuit.
Question, just curious, but the circuit to the spa, is it 120/240 or a straight 240V.
Either way, you cannot tap the circuit.
|
|
 |
New Member
|
|
Mar 22, 2012, 12:15 AM
|
|
Sir I didn't got u please explain me the reason.plz send your answers on my email [email protected]
|
|
 |
New Member
|
|
Jun 20, 2012, 01:09 PM
|
|
The answer is physically yes . You could do this . Is it in compliance with the national electrical code ? The answer is emphatically no , no , no . The first thing that stands out as a 1000 pound gorilla in the room is the fact that the hot tub wiring is protected off the 50 amp breaker . The wiring you are connecting for 110 V is rated at 15 A . As well you could easily electric youth somebody in the hot tub . As well if you installed the ground fault circuit interrupter device as per the national electrical code . The moment that you energized anything on the 110 V circuit your power would be shut off . If electricity leaves the ground fault circuit interrupter breaker and does not return on either the other hot leg or the neutral the ground fault circuit interrupter breaker will send the disparity in current and shut off the circuit . In short you don't power things from other circuits in a house . You crawl a little bit further and run the wire off the main electrical service .
Link Removed
Do not do any electrical work if you do not hold a State License .
|
|
 |
Uber Member
|
|
Jun 22, 2012, 06:41 PM
|
|
 Originally Posted by ElectricianMan
Do not do any electrical work if you do not hold a State License .
States vary regarding who can install electrical wiring. Unless regulated by the state/ city/ county where you live, anyone can wire a house as long as it meets the NEC. There is nothing in the NEC that says only licensed electricians can use this book or install wiring. I am not a licensed electrician but have wired 2 houses from the main panel out, had both permitted and inspected and had no issues.
|
|
 |
New Member
|
|
Aug 29, 2012, 06:20 PM
|
|
U should never share a nutruel to an afci or FCI. The will always trip.
|
|
 |
Uber Member
|
|
Aug 30, 2012, 04:34 AM
|
|
Plese do not use chat type, use full words, use spell checker, and accurate terminology.
 Originally Posted by pjdiaz
U should never share a nutruel to an afci or FCI. The will always trip.
Your statement should read as follows:
"You should never share a neutral to an AFCI or GFI. The will always trip."
|
|
Question Tools |
Search this Question |
|
|
Check out some similar questions!
Free electrical questions
[ 5 Answers ]
I have installed 6 insulated can ceiling lights. They are on one circuit controlled by a Levaton paddle switch with a slide dimmer rated at 600w.The bulbs are phillips 60 watt halogen spots for a total wattage of 360w. They have worked fine for about a year usually run at about halfway on the...
Free answers to electrical questions
[ 1 Answers ]
I was called upon to try and fix a GFCI in a bathroom that occasionally trips. There is a 12/2 20 amp feeder coming into a three gang plastic box. In the box are the GFCI, a single pole switch to a fan, and a dimmer switch to a lighted medicine cabinet. Occasionally, the GFCI trips after you turn...
View more questions
Search
|