Ask Experts Questions for FREE Help !
Ask
    shurgood's Avatar
    shurgood Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 20, 2012, 01:44 PM
    How to remove flywheel on briggs and straton 19.5 engine
    Need to remove flywheel on a 19.5 hp briggs and straton engine
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Aug 26, 2012, 04:01 PM
    Hi,
    You must find a way to keep the engine from turning over and then usually with a 15/16" socket loosen the nut. If you do not have the needed puller, back the nut off up to the top of the shaft, take a pair of hammers(one a ball pein), place ball of the ball pein hammer on the tip of the shaft and strike the flat face of that hammer with the other, Something to carefully lever upwards pressure on the outside edge of the flywheel may prove of assistance. Usually one or two blows is sufficient. Do NOT strike the flywheel directly as that will break the stator magnet loose.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

5HP Briggs Engine Shears Flywheel Keys. Why? [ 4 Answers ]

I have a 5 HP Briggs on my go kart. It has sheared 3 keys already, and I am getting tired of replacing them. The keys are aluminum, and I was wondering if it would hurt to place a steel one in there. Would it do more damage than good?

I have a Generac G27H pressure Washer with a 6.5 Briggs and Straton engine Intek. [ 0 Answers ]

It has run well but now not generating good water pressure. Getting enough water to gun so line looks fine.

How to replace flywheel key on 12 hp briggs I/c engine or how to check if it is shear [ 0 Answers ]

I was wondering how to tell the flywheel key on a 12hp briggs I/c engine is sheared and if so how to replace it

I have a briggs & straton 16.5 OHV engine that will not crank. [ 12 Answers ]

I have had starter checked OK, Battery good, leads good, carb good, fuel changed and lines good, cleaned out distributor head good,breakaway in shaft changed,spark plug changed, oil changed. It will turn over slowly but not start. Has fire at plug and fuel at carb. Need help. What should I try next?

Briggs straton 17 hp ohv engine [ 1 Answers ]

I have m abriggs and straton 17 horse power mower engine,, it will run OK, for about 15 min... Then it gets hot and just stops runinng,, it cools down will start again run a little while stop again,, I put a ne coil on it did help a little but stills stops. What can I...

View more questions Search