Symmons temptrol catridge replacement

Robert Babiarz Posts: 2, Reputation: 1

New Member

Aug 6, 2012, 08:41 AM

Symmons temptrol catridge replacement

I don't know how to replace the tub shower catridge for the symmons temptrol. I removed the face plate and the big nut thet the handle goes through and where do I go from there.

Check out some similar questions!

Symmons temptrol repair [ 0 Answers ]

I had a pretty good leak and after replacing two of the washers from the repair kit, and putting the shower symmons valve back together the water will not shut off when I turn the control handle/valve all the way to the off position? Is there another internal part that is not working correctlu or...

Symmons temptrol [ 1 Answers ]

I have a Symmons Temptrol with a problem. I recently installed an on demand hot water heater and when I was done, I can't get a hot bath. Really hot shower, but not a hot bath. I am trying to get the T-31 knob off and I can't get it off the spline on the TA-10. Been there 30 years. Any...

Symmons '76 Temptrol Model A [ 19 Answers ]

Hello, I purchased a TA-10 to replace the spindle in my Symmons '76 Temptrol Model A. After removing the original spindle I notice that the replacement part is different. Namely, there is no thread on the largest circumference part on the replacement part whereas the original has a thread....

Stuck on a Symmons Temptrol Cartridge Replacement [ 3 Answers ]

Hello, I have a 10 year old plus Symmons temptrol shower/bath unit. I have removed the handle and the face plate. Now I'm down to the part number shown in the image below part # T-11 . It won't budge. I'm curious if I should crank on this and it will turn or pull it straight out. Any...

Symmons temptrol - no water [ 2 Answers ]

I'm getting nothing but a dribble on hot and cold, tub or shower settings. Was fine until today. Any way to tell if it is the valve or seat? There's nothing else to replace, right? Thanks

View more questions Search

Check out some similar questions!

Add your answer here.