 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Why am I having a hard time getting my rudd furnace and hvac repaired
My repair man for furnace and air conditioner wants to replace my old rudd system that is old and ailing with goodman products, is that a good idea? My old system is out dated and needs repair
|
||||
Check out some similar questions!
I have a octopus furnace and I just had it repaired but the heat controller had 2 wires before the repair was done and ran very well. When the repair was completed the air controller had only one wire and it's rattling the vents, should my furnace have two wires to the heat controller and why is it...
I have an older Rudd furnace (at least 20 years old) and it went out yesterday. A handy man came and replaced the thermostat, then the transformer and then the thermocoupler. After he replaced the thermocoupler the furnace came on and seemed OK. After he left the furnace went off again. I went...
Furnace light once then won't relight unless I turn off the thermostat then it will relight once and the transformer stay on with a buzzing sound
The flame sensor is clean, but won't ignite. Fan just runs. No heat
KEEP all posts on same thread.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
