Ask Experts Questions for FREE Help !
Ask
    Marvin65's Avatar
    Marvin65 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 23, 2012, 09:08 AM
    Heat will not come on igniter will not get hot enough to lite
    I am on solar .the ignighter does not have time to get hot enough to lite unit shuts down .I can start gen and all is well most of the time .I have two units .a 2ton&a3ton. The contractor bailed said he was getting me a lifetime warranty .
    But disappeared. Before.
    Is there a way to extend the timer by 1 or 2 seconds?
    My e mail (mhhinshaw@ EarthLink.net)
    My cell 408-512-0049
    Please help!
    Thanks Marvin hinshaw

Check out some similar questions!

No heat, igniter not heating up, thermofuse is good. [ 0 Answers ]

The vent is clean, I replaced the igniter, thermofuse and tested the thermosensor next to the igniter and it has continuity. Any other suggestions? Oh, its only 15 months old... piece of ----... thanks Maytag neptune #MDG5500AWW

RE No Heat.Igniter [ 2 Answers ]

Another question, The igniter does not glow when the furnace blower comes on.. I did check it out with diagnostic test and it glowed during the test

Igniter won't fire blower comes on and then gas but not igniter, status light on [ 0 Answers ]

Furnace won't lite up when I turn on the heat. [ 0 Answers ]

I have a older lennox (model # g1203-110 ) and change the thermocouple.The problem is that does not lite up when I turn on the heat. The fan works fine from the thermostat when I put the thermostat to fan on position and pilot stays on and I even hear it humming like it wants to go on but...

Hot surface igniter [ 1 Answers ]

I have an Evcon model DGAT070BDC mobile home furnace. The burner will not light. Suspect igniter. How can I tell if it is bad and what is the proper procedure to replace it.

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.