Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Troubleshooting Sears Lawn Tractor
[ 10 Answers ]
Troubleshooting Sears LT with a 17.5 2006 B&S Engine.Unit won't start. Isolated problem to fuel solenoid on bottom of carb. How is the solenoid wired into the system? Is there an interlock safety switch that might be the culprit?:confused:
Sears lawn tractor troubleshooting
[ 1 Answers ]
I have a sears 917273170 tractor and I need to locate the interlock switches for the brake/clutch
Sears Craftsman Lawn Tractor 17.5 HP B&S Engine
[ 2 Answers ]
Had a bad starter motor replaced replaced start solenoid and magneto. Tractor will now start and run fine for 5 minutes. Or so then die. Won't restart. Also replaced battery and did a tune up. Checked fuel solenoid and it's not shorted or open. Battery is charging when tractor runs. This is...
Sears lawn tractor troubleshooting
[ 0 Answers ]
I have a sear B&S lawn Tractor, It starts and Runs Fine as long as t I have the clucth pushed in. If I release the clutch or try to engage the blade, it dies. Even if it is in nuetral. Does anyone one know why.
Sears Craftsman Lawn Tractor
[ 4 Answers ]
I have a 10 HP Craftsman lawn tractor that will not move. The clutch works and it goes into gearbut the flat wheel spins and the gear wheel seems too have not enough pressure on it to move. Could this be just a loose drive belt? Thanks, Charlie View more questions Search
|